Tetra Shower Grate - Square Holes - Stainless Steel - 120mm width Standard Length - Gunmetal Grey

DrainTEK Product Code : SSG-IND-SH120-1223-B-CFG

These standard-size shower grates are manufactured by DrainTEK, designed with square punched holes to suit square styled bathroom fixtures and accessories. Being 1.2mm thick stainless steel, the quality and value-for-money is superior to most shower grate products on the market. Finished in electroplated gunmetal grey to match matte black bathroom fixtures and accessories. Choose from 3 standard sizes: 900mm, 1000mm, or 1200mm.

Read more
$394.95
- +
Add to Wish List
Item dispatched within 1 business day All our products are stocked in Australia and are ready to ship to you.
Favourite Favourite

Bathroom Drain - Modern Gunmetal Grey with Punched Square Holes

DrainTEK's Tetra shower grates are manufactured in Australia and are the best choice for any new build or renovation. Being 1.2mm thick stainless steel, the quality and value-for-money is superior to most shower grate products on the market. The Tetra drain grates with square punched holes are water-tight and have a V-profile drain tray designed for efficient water drainage. This slot drain has a contemporary electroplated gunmetal grey finish to match your black bathroom accessories.

Highest quality linear drains for premium bathrooms

  • Full stainless steel
  • The tray in all materials is 1.2mm thick for superior strength
  • 27mm deep V profile drain tray for efficient water drainage
  • Full welded water-tight construction
  • 40mm diameter centred outlet - suitable to fit inside all waste pipe sizes

Highest Specifications


Tray

  • Comes in 3 standard sizes to choose from: 900mm / 1000mm / 1200mm
  • Full stainless steel tray and outlet (1.2mm thick)
  • Electroplated gunmetal grey finish
  • V profile with 27mm depth for efficient drainage
  • 40mm diameter centred outlet - suitable to fit inside all waste pipe sizes
  • Watermark licensed under WMTS-040 - Certificate 23396


Lifetime Warranty

  • Lifetime guarantee against manufacturing defects

 

Dimensions

Click on the icon below to download the PDF manual for this product


Typical Installation Steps

  1. Construct shower surround in accordance with structural requirements leaving a penetration for drainage
  2. Add a suitable drainage flange and fasten/bond in place and cap during the building phase. DrainTEK recommends using a suitable puddle flange with an internal diameter large enough for the shower grate outlet to fit loosely within
  3. Complete water-proofing in accordance with AS3740 with waterproofing turned down into plumbed drain
    Note: Do not integrate tray with the water-proofing as steel expands/contracts differently to other materials
  4. Adjust height of adjustable puddle flange (if installed) to suit desired shower grate height If your tray outlet is not attached, then adhere with a waterproof adhesive sealant prior to installation and ensure it is secure
  5. Set tray at required height in mortar so the finished tiles will be just above the top edge of the grate tray

drainTEK Lifetime Warranty

Every drainTEK drain grate you purchase includes a lifetime guarantee against manufacturing defects.  For details, read the warranty terms and conditions on the drainTEK Warranty Protection page.

Write Your Own Review
You're reviewing:Tetra Shower Grate - Square Holes - Stainless Steel - 120mm width Standard Length - Gunmetal Grey
Your Rating